2013 - 2.2Sporty - Winning Rig at Holmes Hobbies Nationals at Watson Lake AZ!
I am taking details of my rig! If you have any questions, please!
The based rig is Wraith, body is Parma X-citer 1/10, Takashima Design painted body! Rig weight is just about 2,300g!
Original Front upper link plate, main chassis and rear upper link plate!
To have Extream LCG, I put servo vertically!
?? When? I have no idea when I got the nice curved ....!
Front, 2 carbon plates structure, VP Wraith Knuckles, VP C-Hub, Lusford Ti-Drag link, VP Ti- bended Steering link with sweet ti-sliders from Dlux!
Main chassis is fully original, putting Wraith stock gearbox with Yokomo SD-630 spur adapter with Traxxas 54T32P spur, Robinson 9T32P pinion gear. Stock Wraith driveshafts!
Original adjustable rear-upper link plate! Battery mount, HR's link mount version 2 is for the link mounts!
Using HR's Link Mount Version 2 for Front too!
The AR60, Wraith Axles, narrowed 2cm. Almost as same as XR10 front axle width. BTW, I have shaved diff case too much? or ran too much?
I have put 10mm x 15mm metal tube inside of the axle and tighten with total of 4 screws from front and back!
Servo, it was difficult to avoid hitting the drive shaft and lower links, upper links! Daug's spring retainers are nice!
Total of 4 screws to put upper link plate. Its stiff enough for the servo and also upper links!
Spur and gearbox is completely inside of the chassis to avoid from troubles!
Stock Wraith grearbox with stock output shaft. I will upgrade to Crawler Innovation's 4340 soon!
Using SD-630 Spur adapter, I needed to drill holes to install traxxas 32pitch spur.
I have mounted the lower link's rod end horizontal.
Holmes Hobbies motor is on! 5 slot 16t and 4cells - MaxAmps 430mA = smooth and powerful!
MaxAmps 430mA 4cells is going to be on the rear side of the rig. Wanted to put as low as possible, this is my answer!
Another shot of the battery mount!
Instead of putting the rear knuckle weight, I put battery on it!
I realized that I should have put flat head screws for the battery mount! Dont you think so?!
Shaved HB rover white with a lot of air holes weight average of 73g each.
Using VP DH Pro Comp + 4 slugs, 585 offset hubs! Inside of front tires, I am using shaved 5.5 closed cells + proline memory inners for the outer!
VP SLW V1 NT (0.7) + 225 offset hubs for the rears! Inside of rear tires, I am using shaved 6.0 closed cells + proline memory inners for the outer!
Chassis height, 1G proportion from side.
Belly height = around 6cm.
Maximum belly height from side.
Front side = 8.5cm
rear side = 8.7cm
Need flexibilities! almost neutral flex. Little axle steer for the trace abilities.
Maximum right side flex angle.
Maximum right side flex angle.
If you have any questions, please feel free to ask me!
Written by Yoshiaki Kataoka
This product was added to our catalog on Thursday 17 October, 2013.
