YSS 3 Holes Rear Weight Carrier for XR10! [pair]

YSS 3 Holes Rear Weight Carrier for XR10! [pair]

This is rear weight carriers for XR10! Now, not only the front knuckles, you can add the weight to rear adapter! Putting the weight on rear axle, you can amazingly earn low control gravity to your rig!

There are 2 different types that you can add the slug weights. Both works with stock XR10 rear adapters and also the VP rear adapters.

3 holes type:

• If you are running your rig with not much weight on front, 3 holes type is what you want to start from. add some weights to your rig and learn more how it works with your rig!
  

4 holes type:

• If you are running your rig with a lot of weight on front, 44 holes matches to your rig. Take time to think and try to balance front and rear of your rig.
  

Product Images:




Below this point are examples.



Accept Clock-able situations.

Use VP 1.9 wheel slugs!

Drill 3mm hole to install, before drilling the hole, you will need to setup the angle.



All screws are included to install!



With stock XR10 wheel, you will need to grind down just a little to install.

VP DH Pro Comp + 335 Offset Hubs, no problems!

SLW .7" + 225 Offset Hubs, no problems!