Build up Axial Super Class XR10! Part 3!
Now, I cant wait to run this rig, so I wired all electric parts within an hours! so mess, but it can run!
Wow, I forgot to make tires! Proline's 1/2 offset wheels are in my storage, so I am going to use this wheels!
Flatten the hub, I am going to install SLW offset hubs!
I also narrowed the wheels!
Putting SLW offset hub were so easy!
Testing body is on! I have been using this body since I was building the Berg V1 2008!
Oh,,, no,,,, My super XR10's setup is so bad, tires are no grip.... I have to adjust at least, shocks and tires!!
I have also bended lower links too! Went really great setup!
I have ran the rig outside, it was ok.... Not great, but its ok.... So! I am going to make tires now!
Putting the cutting line to the tires, use hub and screws, much better circle you could write on tire.
See the cutting line! I think this is really good idea!
Cut the tires!!
All ready! I have cut the rover too!
Step by step, using the super glue. 3cm at once... take so long to complete!
Yes, one tire is done! took me more than 30 min!
I have made 4 tires, so I am moving to inner foam setup! Using closed cells! 6.0T!
Wow, I am using bunch of closed cells!!
Inside is 6.0T Closed Cells, outside is Panther memory inner!
Putting on to wheel! Looks like something very sweet! This is what I wanted! wide and not so big tire!
This is the second time bringing out! How is the rig going?
Runs so good! More than expected! I have no idea where to run because this is the first time? to run the Super Class!
Rear steering is so complicated, but it has really great possibilities to the better run, I will need more practice!!
Oh! No! Tires are tearing! I knew why,,,, I forgot to make air holes to tires!!! My fault....!
テスト走行も行い、かなりの走破性を見せたスーパーXR10！次回は、タイヤ修復をメインに行い、ホイールハブ部分の強化などを行いたいと思います！
Written by Yoshiaki Kataoka
This product was added to our catalog on Wednesday 29 August, 2012.
