Axial Capra Build Vol.2

5.If you are struggle with bearings, use shaft and draw circle and pull them out!


6.Any ways can be installed. Doesnt have to install all.


7. You can do this too!


8. I installed fully! So beautiful brass beauty!


9. Its 170g, compare to stock, 134g heavier!


10. Do work for less than 20 minutes, done!


11.ナット部分もいい感じの精度がでているのではないでしょうか！


12. There are not much clearance between knuckles and wheels.


13. Be careful choosing the rims, because the portal axle's knuckles need spaces!


14. I have already put some weights in the rims, so it might be too heavy, but I will anyway run first and see how it goes! 


15. I recently made SCX10-III and didnt put weight in the wheels, so I think I am going to switch rims and tires with this rig!



Have a great hobby time!