Axial Racing SCX10 III Build Vol.02
Here comes the New SCX10 III Build! Mods!
1. Went to Field! Gearing is too high?
2. Its hard to drive on the rock, maybe the motor setup?
3. Great rear view!
4.Put some wheels and tires!
5.I am going to change these electrics!
6.This servo is so good, I installed to Capra too!
7.Who dont like this ESC, I think no one! Great ESC!
8. I installed 11T TerraX motor to it!
9.Wiring done, put 11T pinion gear to it!
10.How it looks? Great, isnt it!
11.WP-1080 is installed too!
12.Great place to hide switch! It can ON-OFF from not only inside but outside!
13. I also installed Capra's over drive gears to it!
14. No problems at all! Clean installation!
15. Had fun on the ROCK! still want she to be slower, so decide to gear down again!
16. Also installed aluminum bumper mounts! You also can install servo to it!
17.For the rear too!
18.Put steering servo to it!
19.Steering drag link also! 80mm is the best length for it!
20.Looks really nice!
21. I want to install something to the hole...
22.Installed rear bumper mount too!
23.I have just figure out how to put 9T pinion gear using stock motor mount, put it to 13T hole and 14T hole works just fine!
24.I also bought Futaba 4PM, great 4 channel transmitter!
25.For the gearbox, I used 3rd channel and mapped to SW1.
26.For the DIG, I used 4th channel and mapped to SW2.
27.Here is the configuration to it, I just mapped channels and switches.
28. EPA setting to it and done!
Lets enjoy!
YSS Crawlers - Yoshiaki Kataoka
This product was added to our catalog on Saturday 08 August, 2020.
