RC Bros Berg V1 Ultimate Conversion Set! [Front-Rear Tubes]]

When it comes to a stock berg tube you lack three things that are extremely important when competing; Weight, Diameter and Adjust ability. Our front Berg tubes have all these important attributes and all the details can be found below!

Our tubes are constructed of ultra strong and lightweight 7075 aluminum with nearly the entire diameter at .45″ giving you the ultimate in clearance!The tubes also feature an adjustable 4 link mount and splined tube ends allowing for a quick and easy splined C-Hub that will need to be installed by the customer (minor fab skills require, a drill and a tap are needed)

Each link mount features diamond etched degree mounts as well as a single etched mark on the axle tube which truly allows setting the link position a snap. Align both to your desired locations, mark the hole location and drill and tap. Once the first hole is set, follow through the next. Please use red or green loc-tite

The outer tube is splined specifically for a Vanquish splined C-Hub. This allows adjusting caster a quick and painless process.

Our tubes come pre-notched and a provided servo mount included allowing the customer to quickly add a servo of there choice. Please note the buyer will need to create there own servo shims to shim the servo to there desired height. Each tube and shock mount features diamond etched markings allowing the user to accurate measure for mount.

All these combined the entire kit comes in at 43 grams keeping the weight low! Lightweight, adjustable and small in size, this is the ultimate combination!

Option Explanations:Chub Machining Service: This is for those wanting to send us there current Chubs to be machined for to fit our splined tubes. Please allow 1-2 weeks for this process to be done and your order to be shipped out. Our address can be found below:
RcBros
6681 Brooklake RD NE
Brooks, OR 97305

Machined VP Chub: This for for those wanting to purchase new Chubs with the process already done. This means no need to ship us anything. Please allow 1-2 weeks for this process as well.

Install instructions found here: http://www.rccrawler.com/forum/enroute-berg/444501-how-install-rcbros-light-weight-7075-tubes.html

When it comes to a stock berg tube you lack three things that are extremely important when competing; Weight, Diameter and Adjust ability. Our rear Berg tubes have all these important attributes and all the details can be found below!

Our tubes are constructed of ultra strong and lightweight 7075 aluminum with nearly the entire diameter at .45″ giving you the ultimate in clearance!The tubes also feature an adjustable 4 link mount that will need to be installed by the customer (minor fab skills require, a drill and a tap are needed).

Each link mount features diamond etched degree mounts as well as a single etched mark on the axle tube which truly allows setting the link position a snap. Align both to your desired locations, mark the hole location and drill and tap. Once the first hole is set, if a second hole is desired there is room for one more.

The outer bearing is held in via a c-clip. These c-clips are a one time use clip and with that in mind we have notched the tube end for easy clip removable. 2 extra clips will be included with each order. If more are desired they are available for purchase separately.

Lastly, a spacer is included to separate the hex pin away from the bearing, this is there to keep the offset spaced out to keep the wheel from digging into the aluminum.

All these combined the entire kit comes in at 40 grams keeping the weight out of the rear allowing for ultimate tunability! Lightweight, adjustable and small in size, this is the ultimate combination!

 NOTE: These will not fit the Dlux Aluminum Axle Shafts!!! We will have a set ASAP to accommodate these.