7.Threadlock and grease are included.
8.BAG-A, Front Axle!
9.TIPs！Threadlock is better to use like this.
10.Great to have bigger bearing.
11.smoooth!
12.Lets it more smooth with it!
13.everything are smooth, great.
14.Oh, usual bearings?! I wanted to have bigger bearings here too.
15.Nice steering angle we will earn.
16.All smooth and ready to go next step!
17.All done! Great looking front axle!
18.BAG-B, Rear axle build!
19.I used this plier「
YSS プロテックRC[Protek RC] ツルゥトルク[TruTorque] ショックシャフトプライヤー！」
20.No more pain for the hoding gears and so on.
21.great looking cap!
22.Front and rear axles are done! smoooooth!
23.C channel chassis is the next step to go.
24.All the parts from the bag.
25.Half way done, not take long time to build chassis, I think.
26.Is this parts the same? Looks different...
27.Perfect fit! It was ok.
28.Chassis done!
29.What a smooth under side, great!
30.Now, we are moving on to the VFD Twin Transmission build!
31.Prepare the parts need, and build them!
32.I didnt loosen the nut, I dont want any slippery transmission.
33.Same tooth but thinkness are different.
34.Use thikker one!
35.Check the smoothness everytime you put something.
36.Great looking transmission!
37.DIG and Overdrive grears, good so far!
38.What you need is smoothness.
39.If you plan to use DIG and OD servo, dont tighten up the screws.
40.Here and
41.here, just put it on.
42.All done, still check the smoothness. Mine got finish with smooth!
Lets enjoy!
YSS Crawlers - Yoshiaki Kataoka
